Resetting The Lock - Kaba E-Plex 5200 User Manual

Performing Manual Diagnostics (Command 500#)
Use the Diagnostics code to perform manual diagnostics of the lock, green LED, red LED,
buzzer, and the twelve pushbuttons—0 through 9, * and #.
Note: You will need the M-Unit/Palm PDA to perform these diagnostics.
Required User Level: Master
1. Put the lock into Pushbutton Programming Mode.
2. Enter command 500# for Diagnostics. You will see a green LED and hear a high beep
followed by a red LED and a low beep.
3. Press 123456789*0#, in that exact order, to test each pushbutton. If every pushbutton is
working correctly, you will see a green LED and hear a normal beep for each pushbutton
that is pressed.
Example of Complete Entry: 500#123456789*0#.
4. Enter another # to indicate the end of programming.
5. If you see a red LED at any time that you are pressing a pushbutton, or at the end of the
code, there could be a problem with the pushbuttons.
6. Enter another # to indicate the end of programming.
7. If you still see the red LED, the lock has a problem. Call a service person to repair or
replace the lock.
Identifying a Lock Model (Command 501#)
Use the Lock Model Identification code to identify if the lock model is E-Plex 5200 or E-Plex
5700.
Required User Level: Master, Manager
1. Put the lock into Pushbutton Programming Mode.
2. Enter command 501# for Lock Model Identification.
3. The lock will flash the red and green LEDs twice with accompanying high-pitched tone for
E-Plex 5200 and seven times for E-Plex 5700.
4. Enter another # to indicate end of programming.

Resetting the Lock

You can return to factory default parameters by performing a Hard Reset. This returns the
lock to Factory Mode including deleting all codes, putting the lock back to factory default
values (4-digit access code length) and making the Master code 12345678. Also, the lock
function will revert to the default "Entry" function. A hard reset is performed as follows.
1. Insert the key, turn to retract latch, and hold in open position.
2. Within 5 seconds, press # and then release the key.
3. While red/green light flashes, press 12345678# on keypad.
The lock will reset. You will see two flashes of the green light with a corresponding high pitch
tone, followed by the motor "crunch," indicating that the reset is successful.
The lock is now reset to the Factory Mode and the Master code is now 12345678.
E-Plex Advanced ACS User's Guide
Operating the E-Plex Lock at its Keypad
PKG 3114 0106 4–7