Table of Contents
Advertisement
General Maintenance
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one
of two reasons:
I.
The hardware was not sufficiently tightened during assembly. All bolts that were
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the service
department for noise issues can be traced to loose hardware.
II.
The crank arm nut needs to be retightened
III. If squeaks or other noises persist, check that the unit is properly leveled. There are
2 leveling pads on the bottom of the rear stabilizer, use a 14mm wrench (or
adjustable wrench) to adjust the levelers.
MAINTENANCE MENU IN CONSOLE SOFTWARE
The console has built in maintenance/diagnostic software. The software will allow
you to change the console settings from English to Metric and turn off the beeping
of the speaker when a key is pressed for example. To enter the Maintenance menu
(may be called Engineering mode, depending on version) press and hold down the
Start, Stop and Enter keys while pedaling. Keep holding the keys down for about 5
seconds and the message window will display "Engineering mode menu". Press
enter to access the menu below:
a. Key Test (will allow you to test all the keys to make sure they are functioning)
b. Security (Allows the keypad to be locked to prevent unauthorized use)
c. Functions (Press Enter to access settings and Up arrow to scroll)
i.
Sleep Mode
inactivity)
ii. PWM Test (Tests the brake resistance)
iii. Beep (Turns off the speaker so no beeping sound is heard)
iv. Units
v. ODO Reset (Resets the odometer)
vi. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause
indefinitely)
d.
LCD Test (Tests all the display functions)
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
(Turn on to have the console power down automatically after 20 minutes of
(Sets the display to readout in English or Metric display measurements)
25
Dyaco Canada Inc. 2013
Advertisement
Table of Contents
