Table of Contents
Advertisement
2
Advanced power control
The NSO-II can be wired
and configured to control
the power of displays and
compatible devices. See the
NSO-II Installation manual for
more information.
14 |
Basic operation
Turn power on/off
Use the power switch on the front of the NSO Processor
or press the PWR key on the OP40 Remote Control to turn
the NSO-II system on/off.
More features via the power key
•
Press the OP40 PWR
key or tap the power
button on the Pages
panel
•
Drag to adjust
slider value / repeat
pressing the OP40
PWR key
¼ Note:
If the power key is released before shut-down is completed, the power off is can-
celled.
A night mode which optimizes the color palette for low light conditions, is included.
¼ Note:
Details on the chart may be less visible when the Night mode is selected!
When in Standby mode, the backlight is turned off to save power.
You return from Standby mode to normal operation by pressing the OP40 PWR key.
If the radar is transmitting you can set it to standby mode from within the
Using the touchscreen
Basic touchscreen operation on the different panels is shown in the table below.
The panel sections later in this manual have more information about panel specific
touchscreen operation.
Menu/
Operation
Dialogs
Select/
Tap
toggle item
Press and
hold
Adjust
slider value
Drag
Scroll dialog
¼ Note:
When pressing the screen and holding your finger on the same spot, a circle will
spin around the point. Don't let go till action circle is completed or until the action is
confirmed by a second beep.
Basic operation |
NSO-II Operator Manual
Power switch
Display dialog for
brightness, night mode,
standby mode and radar
standby/transmit
To change the brightness
level / toggle preset
brightness levels
Panels:
Chart
Echo
Place cursor
Display menu for active panel
Pan echo history
Pan chart
(horizontal
(any direction)
movement)
Light
dialog.
Radar
Advertisement
Table of Contents
