Table of Contents
Advertisement
96 |
Setting up multiple WIFI-1 units
On large or metal hulled vessels it may be necessary to connect multiple WIFI-1 access
points to extend the range.
Up to 2 WIFI-1 units can be connected to one NSO-II, but only the WIFI-1 unit defined as
primary access point can be used for connecting the wireless device to the NSO-II.
1.
Open the access points' dialog as shown above
2.
Activate the line for the connected WIFI-1 unit, and re-define this to be a secondary ac-
cess point
3.
Connect and define the additional WIFI-1 unit as described in "Setting up the WIFI-1" on
page 95.
-
The latest connected WIFI-1 unit will now be the primary access point, and only this
can be used for connecting the wireless device to the NSO-II.
Selecting communication channel
The WIFI-1 unit will automatically select the channel used for communication with the
wireless devices.
You might need to change the channel if other transmitting devices cause conflicts
(multiple networks, wireless phones etc), or if you are using the equipment in areas with
restricted channel selection.
The channels can be manually changed from the drop down list.
¼ Note:
Only technically skilled persons should set up multiple WIFI-1 units or change the
communication channel!
Connecting the wireless device to the WIFI-1
Set up the wireless device's network to be the WIFI-1 defined as primary access point.
-
Network name
The
page 95.
GoFreeTM wireless |
NSO-II Operator Manual
is found in the NSO-II menu. Refer to "Setting up the WIFI-1" on
Advertisement
Table of Contents
