Table of Contents
Advertisement
5
Navigating with the NSO-II
The navigation function included in the NSO-II allows you to navigate towards the cursor
position, a waypoint or along a predefined route.
For information about positioning waypoints and creating routes, refer "Waypoints, routes
& tracks" on page 26.
Goto menu
Goto
menu, press the OP40 GO TO
You can start navigation from any panel by using the
key.
¼ Note:
The Goto cursor option will only be available when the
cursor is active on a Chart, Radar or Echosounder panel.
When the NSO-II starts navigating, the cross track limits will be
indicated on the chart. See "Navigation settings panel" on page 30.
Navigating on the chart
Goto
You can start navigating on the chart from the chart menu and from the
menu. The
Goto
description and the illustrations below show use of the
menu, activated by pressing
the OP40 GO TO key.
Navigate to cursor position
You can start navigating towards a point on the chart by tapping the selected destination,
Goto
activating the
menu and selecting the cursor option.
Navigate a route
You can start navigating a route by tapping the route and then activating the
Goto
menu.
When route navigation is started, the
Goto
menu will expand showing options for
skipping a waypoint, or for restarting the route from current vessel position.
Selecting start point
You can navigate a route, starting from any waypoint, by positioning the cursor over the
selected waypoint and activating the
Goto
menu.
| 29
Navigating with the NSO-II |
NSO-II Operator Manual
Advertisement
Table of Contents
