Table of Contents
Advertisement
15
¼ Note:
Video
The video function allows you to view videos or camera sources on your NSO-II screen.
For information about how to connect the camera, see the separate NSO-II Installation
manual.
The video images will not be shared via the network. You can only view the video
on the unit connected to the video source.
Video panel
The video image will be proportionally scaled to fit into the video panel. Area not covered
by the image will be colored black.
The graphics below show images from a thermal imaging camera.
Video menus
When you tap the video panel, the video panel buttons are displayed. Tapping the screen
again makes these go away.
When the video panel buttons are active you can display the full video menu by:
Setting up the video panel
Video source
NSO-II supports two video input channels. You can select to view one channel only, or to
cycle the image between available video cameras.
The cycle period can be set from 5 to 120 seconds.
Adjusting the video image
You can optimize the video display by adjusting the video image settings. The settings are
adjusted individually for each video source. Default for all settings: 50%.
Mirroring the video image
Video input can be set to display a mirrored image. This setting can be helpful for rear-
Video |
NSO-II Operator Manual
•
Pressing the panel button or
MENU
the OP40
key
•
Pressing and holding on the
video panel
| 85
Advertisement
Table of Contents
