Audio; Enabling Audio; Audio Media Bar; Setting Up The Sonichub Speakers - Simrad NSO-II Operator's Manual

Hide thumbs Also See for NSO-II:
Table of Contents

Advertisement

13

Audio

When the NSO-II is connected to a SonicHub server you can use your unit to control audio
playback from iPod, iPhone, USB mass storage device (mp3) and AM/FM radio. Before
playing FM radio you must purchase a marine-grade AM/FM antenna.
When connected to a WM-2 Satellite module you can subscribe and include Sirius™
audio on your NSO-II system. Sirius™ audio and weather service covers inland US waters
and coastal areas into the Atlantic and Pacific oceans, Gulf of Mexico and the Caribbean
Sea. The Sirius™ audio products received vary depending on your selected subscription
package. For more information refer to www.sirius.com.
Before you can start using your equipment, it must be installed according to the
Installation manual included with the unit.

Enabling audio

Audio media bar

When audio is enabled, the media bar will appear at the bottom of the screen on all
pages. The media bar varies from one audio source to another.
Panel buttons
Media bar
You switch focus between other panels and the media bar by tapping on the selected
panel.
Audio menus
When you tap the media bar, the audio panel buttons are displayed. Tapping the screen
again makes these go away.
When the media bar is active you can display the full audio menu by:
The menus differ from one audio source to another as shown in the following sections.

Setting up the SonicHub speakers

Speaker zones
Your unit has four on-board amplified channels for directly driving speakers. There are
also two low level channels (stereo) for supplying signal to an external amplifier, plus two
mono channels for amplified subwoofer(s).
Audio |
NSO-II Operator Manual
You must enable audio to control audio on your
NSO-II unit.
MENU
Tapping the
panel button
Pressing and holding on the media
bar
Volume level
| 75

Advertisement

Table of Contents
loading

Table of Contents