Quick Start: First Weighing Operation - Sartorius CUBIS MSU User Instructions

Setting Up the Display and Control Unit
You can adjust the angle of the tiltable display and control unit as desired to ensure
optimal readability in every situation. The color and brightness settings can also be
adapted to the prevailing lighting conditions (see "User Management" and "System
Settings" for details).
Inserting a Memory Card in the Display and Control Unit
You can copy data, such as application data or user profiles, to an SD memory card.
This is a quick and easy method of transferring settings between balances. The slot
for the SD card is located on the back of the display and control unit.
1
1. Tilt the control unit towards you until it is almost vertical.
2. Lift the cover of the card slot. Hold the card with the metal contacts facing
towards you.
3. Push the card into the slot as far as it will go.
y The card snaps into place.
To remove the card, push it in and then release. The card will pop out for easy
t
removal.
4. Press on the position lock and tilt the control unit back to the desired position.

Quick Start: First Weighing Operation

Push the on/off key to switch the balance on.
A
t
Close the draft shield (if present on your model).
t
Push the TARE key to tare the balance.
J
t
y When the balance has been tared, the readout will show a zero value.
Open the draft shield (if applicable) and carefully place the sample on the
t
weighing pan (in a suitable container).
Close the draft shield (if present on your model).
t
Once the readout has stabilized and the unit of measurement is displayed,
t
you can read off the measurement value.
Information for the User
2
Cubis MSU Brief Instructions 7