Operation; Dmx Control; Stand-Alone Operation - Martin Exterior 200 LED User Manual

Operation

Warning! Class 3B LED product. Do not look into the beam at a distance of less than 2.2 meters (7
feet 3 inches) from the front surface of the product. Do not view the light output with optical
instruments or any device that may concentrate the beam.
The Exterior 200 LED can be operated using a DMX controller or programmed to run a stand-alone light
show without DMX control.
Ambient temperatures
The Exterior 200 LED can be operated at ambient temperatures from -30° C (-22° F) to 45° C (113° F).
At temperatures below 0° C (32° F), leave the fixture permanently powered on, even if LEDs are dimmed to
zero because light output is not required. The standby power will provide a little heat and help protect
circuits and components from the effects of low temperature.

DMX control

In DMX-controlled operation, faders on the DMX controller are used to control color and intensity. The
control method depends on which DMX mode the fixture is set to (see "DMX Mode" on page 18).
In RGB mode, three channels on the controller are used to control the intensity of red, green and blue color
from 0% to 100%.
In RGBAW mode, five channels on the controller are used to control the intensity of red, green, blue, amber
and white color from 0% to 100%.
In HSI mode, three channels on the controller are used to control hue, saturation and intensity. Hue is
controlled in the following order: Red → Orange → Amber → Yellow → Green → Cyan → Blue → Indigo →
Violet → Magenta → Red. Saturation and Intensity can be varied from 0% to 100%.
In HSIC mode, four channels are used to control hue, saturation, intensity and color temperature. Hue,
saturation and intensity are controlled as in HSI mode, and color temperature can be varied from 2000 to
1000 K.

Stand-alone operation

In stand-alone operation, the fixture executes color changes at set intervals and speeds, at pre-defined
periods during the day, and/or when the light level falls below a defined level. The term stand-alone means
that the Exterior 200 LED is not connected to a control device, but is pre-programmed with a sequence of up
to 20 scenes that play continuously in a loop.
Operation 19