Status Indicators - Martin Exterior 200 LED User Manual

Hide thumbs

Table Of Contents

Table of Contents

available from the Martin website (http://www.martin.com) and can be installed via the DMX data link with

the following items:

• The Martin Uploader application, version 5.0 or later, downloadable free of charge from the Support area

of the Martin website.

• The Exterior 200 LED main CPU software update file, downloadable free of charge from the Support area

of the Martin website (this file can be downloaded automatically from within the Martin Uploader

application)

• A Martin Universal USB-DMX Interface or similar PC/fixture hardware interface and a Windows PC (if you

have a Martin MP-2 Uploader device, it can also be used).

Installing software: normal method

1. Connect the uploader hardware to a Exterior 200 LED fixture's data input connector. The software will

be uploaded to that fixture and all Exterior 200 LED fixtures that are powered on and connected via the

DMX link.

2. Upload the fixture software as described in the uploader's help file or user documentation.

3. Disconnect the uploader hardware and reconnect the fixture to the DMX link.

4. Cycle power off and on. Check that the fixture resets correctly. If an error message appears in the

display, cycle power off and on again and check that the fixture now resets correctly.

Installing software: boot mode upload

A boot mode upload may be required if the

software update notes call for it or if the

fixture software is seriously corrupted and

the fixture will not accept a software upload

using the normal method described above.

To carry out a boot mode upload:

1. Isolate the fixture from power and allow

to cool for at least 20 minutes.

2. Open the rear cover as described for

access to the main PCB.

3. Locate the DIP switch on the main PCB

and move pin 6 to OFF.

4. Reinstall the rear cover seal and the rear cover temporarily.

5. Reapply power and perform the upload as described above.

6. Isolate from power, open the rear cover and return DIP move pin 6 back to ON.

7. Check that the rear cover seal is in perfect condition, then reinstall the seal and the rear cover,

cross-tightening screws gradually to 5 - 6 Nm (3.7 - 4.4 ft.-lbs.) and reapply power.

8. Check that the fixture resets correctly. If an error occurs, cycle power off and on again and check that the

fixture now resets correctly.