Recording Function; Troubleshooting - Strong SRT 8110 User Manual

PART 1 • English
5.7.4 Record configure
Record Device
If you have multiple partitions on your storage device – select one of them as default partition for recording.
format
If you would like to format storage device or partition on it – select partition and file system to be used. Move focus to Format
and press oK. You will need to confirm format by pressing oK button one more time. Format procedure will take some time,
depends from size of storage device used. At the end of process "Format is complete" message will appear.
Warning: Format functions will delete all records, data and information from your USB device. STRONG will
not take any responsibility for damaged or lost data on the USB device.

6.0 RECoRDIng fUnCTIon

To perform a recording you have to insert USB storage device into USB port of the receiver. Select a channel you would
like to record and press REC button. The recording will start and at let upper corner of the screen you will see recording
notification with blinking red dot and record duration.
During a recording you can't change a channel to another one.
You can check details of the recording in progress by pressing to Info button.
To stop a recording press SToP button on remote control.
Another way of doing recording is use Scheduler – please refer to 5.4.1 Schedule of this manual.
Average record size (values are approximately, depend from bit rate of actual broadcast):
MPEG2 SD channel – 1 hour take about 2.2 GB space
MPEG4 SD channel – 1 hour take about 1 GB space
MPEG4 HD channel – 1 hour take about 4.5 GB space
Accessing to the recordings. You can access recordings by pressing button lIST on remote control. Also list of recordings can
be accessed through Menu – USB – Multimedia – Records. Please, refer to 5.7.1 Multimedia for details of available functions.
A.1 TRoUblESHooTIng
There may be various reasons for the abnormal operation of the receiver. Check the receiver according to the procedures
shown below. If the receiver does not work properly after checking it, please contact the dealer or the local Service
Hotline. Do NOT open the receiver cover. It may cause a dangerous situation and the warranty will get void.
Problem
Stand-by indicator do not
light up
No signal found
No picture or sound on TV
Scrambled channel message
No response to remote
control
Forgotten channel lock code
Forgotten menu lock code
Possible cause
Mains lead unplugged/multipoint
connector switched off
Front panel switch is in OFF position
Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to switch ON
antenna power/external feed
Input is not selected on your TV
TV or VCR are not connected to main
Bad cable connection
Channel is scrambled
Receiver off
Handset not aimed correctly
IR sensor obstructed
Hand set batteries exhausted
What to do
Check mains lead /switch multipoint
connector on
Set front panel switch to ON position
Check aerial lead
Check aerial
Check with dealer
Switch receiver's Antenna Power ON/
connect external feed
Switch to correct TV input
Check mains lead
Firmly plug in cables between receiver and TV
Select alternative channel
Plug in and turn on plug
Aim handset at IR sensor
Check for obstructions
Replace handset batteries
Contact local Service Hotline or send email to
our Support via www.strong.tv
Contact local Service Hotline or send email to
our Support via www.strong.tv
11