Custom Settings; Fixture Information Readouts; Dmx Signal Monitoring; Test Sequences - Martin MAC Quantum Profile User Manual

Custom settings

The custom configuration function CUSTOM 1 - CUSTOM 3 allows you to save and recall up to three sets
of fixture settings. The savable settings comprise:
• all the settings in the PERSONALITY menu,
• the fixture's DMX address, and
• the fixture's DMX control mode: Extended 16-bit or Basic 16-bit mode.

Fixture information readouts

The following fixture information can be called up in the display:
• POWER ON TIME provides two counters:
- The TOTAL counter is not user-resettable and displays total hours powered on since manufacture.
- The RESETTABLE counter is user-resettable and displays the number of hours the fixture has been
powered on since the counter was last reset.
• POWER ON CYCLES also provides two counters:
- The TOTAL counter is not user-resettable and displays the total number of power on/off cycles since
manufacture.
- The RESETTABLE counter is user-resettable and displays the number of power on/off cycles since the
counter was last reset.
• SW VERSION displays the currently installed firmware (fixture software) version.
• RDM UID displays the fixture's factory-set unique ID for identification in RDM systems.
• FAN SPEEDS provides separate status readouts from the fixture's cooling fans.
• TEMPERATURES provides separate PCB temperature readouts.

DMX signal monitoring

The MAC Quantum Profile provides data on the DMX signal it is receiving in the DMX LIVE menu. This
information can be useful for troubleshooting control problems.
RATE displays the DMX refresh rate in packets per second. Values lower than 10 or higher than 44 may
result in erratic performance, especially when using tracking control.
QUALITY displays the quality of the received DMX data as a percentage of packets received. Values much
below 100 indicate interference, poor connections, or other problems with the serial data link that are the
most common cause of control problems.
START CODE displays the DMX start code.
The remaining options under DMX LIVE display the DMX values in a range from 0 - 255 that are being
received on each channel. The DMX channels displayed depend on whether the fixture is in 16-bit or 16-bit
extended mode.

Test sequences

TEST activates effects in sequence, allowing you to test all effects, pan and tilt movement only, or effects
only (i.e. without pan and tilt movement) without a DMX controller:
• Select a test type and press Enter to start the test.
• Press Enter to pause the test and use Up and Down to select the test queue.
• Press Menu to stop the test.

Manual control

The MANUAL CONTROL menu lets you reset the MAC Quantum Profile and operate the fixture without a
DMX controller. To execute commands in the MANUAL CONTROL menu, select a menu item for the effect
that you want to control, then enter a value from 0 to 255 to apply a command. The menu items and values
correspond to the commands listed in the DMX protocol on page 20.
14 MAC Quantum Profile User Guide