Table of Contents
Advertisement
8.2.4 Emptying the waste bottle
When printing A0 size or larger widths, very small amounts of ink will be ejected on the left edge for stable
printing quality. The waste ink ejected on the left side in that way is collected in a translucent bottle under the
main unit (the waste ink bottle).
Since there is no panel display or lamp display when the waste liquid absorbent sheet in the
Step 1 :
waste ink bottle is to be replaced, you should prepare to replace the waste liquid absorbent sheet
when you see that the bottle is about half full. Have a new absorbent sheet, a thick vinyl bag and
a pair of forceps ready.
Note:
Conditions vary for the waste ink bottle to become half full but it will be after printing
about 2000 A0 pages.
Remove the waste ink bottle by turning it to the left. Using absorbent sheet and forceps, soak up
Step 2 :
the waste liquid in the bottle and discard the waste liquid absorbent sheet into the open vinyl bag.
The waste ink bottle, fitted with new waste liquid absorbent sheet, is installed in the printer by
Step 3 :
turning it to the right.
Caution:
The used waste liquid absorbent sheet should be disposed of as non-combustible
material in accordance with your local civic regulations.
It would dangerous for children to lick or swallow the absorbent sheet filled with waste
liquid, so dispose of it promptly or put it out of reach.
If you accidentally touch the waste liquid, wash with soap and water at once.
If it should enter your eye, wash with plenty of water and see a doctor. If it is licked,
gargle with water and wash out straight away. If it is swallowed, immediately drink plenty
of water and consult a doctor without delay.
Rockhopper 38 – Maintenance Manual
182
AP-74038, Rev. 1.1, 25/01/05
Advertisement
Table of Contents
