3B. Attach Upper Mount (To Wood Framing Channels); 3C. Attach Upper Mount (To L-Brackets) - BIG ASS FANS Essence Installation Manual

18

3b. Attach upper mount (to wood framing channels)

When cutting the wood framing channels, be sure the holes on each end will line up with the holes on the mounting
brackets!
Secure the upper mount (with extension tube and upper mounting brace already attached) to the wood framing channels using the
Mounting Hardware as shown. Tighten the hardware so that it is snug, but do not torque.
Measure the distance between the mounting brackets (bolt head to bolt head) so that the wood framing channels have enough
clearance in between the brackets. Cut both wood framing channels to the measured length.
Proceed to step 4.
Mounting Hardware (BAF-Supplied):
a. (4) M10 x 40 mm Hex Head Cap Screw
b. (8) M10 Flat Washer
c. (4) M10 Nylock Nut
d. (2) Wood Framing Channel

3c. Attach upper mount (to L-brackets)

Secure the upper mount (with extension tube and upper mounting brace
already attached) to the L-brackets using the Mounting Hardware as
shown. Tighten the hardware so that it is snug, but do not torque.
Note: L-bracket orientation may differ from the illustration.
Proceed to step 5.
If the hardware is stainless steel, do not use power tools!
Mounting Hardware (BAF-Supplied):
a. (4) M10 x 40 mm Hex Head Cap Screw
b. (8) M10 Flat Washer
c. (4) M10 Nylock Nut
ESSENCE
Hanging the Fan (cont.)
If the hardware is stainless steel, do not use power tools!
b
c
WWW.BIGASSFANS.COM ©2013 DELTA T CORP.
®
a
b
b
b
ALL RIGHTS RESERVED
d
>1"
c
a