Attach Locking Carabiners To Guy Wire Clamps; 3A. Attach Beam Clamp (Bar Joist Mounting); 3B. Attach Eyebolt (Wood Frame Mounting) - BIG ASS FANS Essence Installation Manual

2. Attach locking carabiners to guy wire clamps

Secure the four (4) locking carabiners to the guy wire clamps as shown.
Securely tighten the carabiners.

3a. Attach beam clamp (bar joist mounting)

The guy wire should be at a 45° angle from the extension tube (see the illustrations on
the following page). Attach the beam clamp to the mounting structure accordingly.
For best results, the guy wires should be installed at 45° in the X-Y, Y-Z, and X-Z
planes as shown on the following page. If the angle deviates by more than 15°, contact
Customer Service for assistance.
Fasten the small eyebolt and nut onto the beam clamp (the nut will be on the outside of
the beam clamp).
Loop the crimped end of the guy wire into the locking carabiner and secure to the
eyebolt as shown. Securely tighten the carabiner.
Guy Wire Hardware (BAF-Supplied):
a. 1/4" Beam Clamp
b. 1/4-20 x 1" Eyebolt
c. 1/4-20 Hex Nut
d. Locking Carabiner
e. Guy Wire

3b. Attach eyebolt (wood frame mounting)

The guy wire should be at approximately a 45° angle from the extension tube (see the
illustrations on the following page). Attach the eyebolt to the wood frame accordingly.
For best results, the guy wires should be installed at 45° in the X-Y, Y-Z, and X-Z
planes as shown on the following page. If the angle deviates by more than 15°, contact
Customer Service for assistance.
Loop the crimped end of the guy wire into the locking carabiner and secure to the
eyebolt as shown. Securely tighten the carabiner.
Guy Wire Hardware (BAF-Supplied):
a. 1/4-20 x 1" Eyebolt
b. Locking Carabiner
c. Guy Wire
ESSENCE
Installing Guy Wires (cont.)
WWW.BIGASSFANS.COM ©2013 DELTA T CORP.
®
ALL RIGHTS RESERVED
25
a
b
d
c
e
a
b
c