Service Procedures; To Remove Control Panel; Timer Removal - Maytag LAT2300 Service Manual

SECTION 3. WASHER - SERVICE PROCEDURES
ALWAYS DISCONNECT UNIT FROM POWER SOURCE BEFORE SERVICING
CONTROLS
To Remove Control Panel
Disconnect washer from power
supply.
Remove the two inside screws from
top of panel and tilt away from
console.
With the control panel cover open, you
gain access to most of the electrical
components.
Depending on the model, you will have
access to the following: timer, water
temperature switch, water level switch,
speed switch, lid switch, micro-
processor board, motor relays and
transformer.
Timer
A timer is a series of switches driven by
an electric motor. These switches
control the fill, agitation and spin of a
washer. These functions can be done
at the same time, such as filling and
spinning, as in the spray rinse.
Timer removal:
1. Disconnect washer from power
supply.
2. Pry the cap off and pull the retainer
clip off the timer shaft. Remove the
timer knob, spring and dial.
Note: The timer shaft pin is longer
on one side. This is to prevent the
dial from being installed incorrectly.
16001145 SECTION 3. WASHER - SERVICE PROCEDURES
3-1
©1994 Maytag Corporation