Vertical Switches (Push Button); Horizontal Switches (Rotary) - Maytag LAT2300 Service Manual

Timer Removal
Knob
Cap
~()
Timer
Dial~_
Tim..
~
Knob~ ~
~~----11me,
~
Dial
~
Spring
"""'- Clip Retainer
1. Remove timer knob, by removing the
cap on the face of the knob.
2. Slide the retainer
"c"
clip off the timer
shaft. Carefully lift the knob and timer
dial from the timer shaft while secur-
ing the spring between them.
Align the Center Rib
11'
on the bottom of the
~ Switch with the Slot in
the Cup on the Bottom
of the Switch
Openin~".fl'I:..."""-'~~
on the Console
2 Pivoting the
. Switch Body, Lock
it in at the Top of
the Opening
on the Console.
1. To remove - Depress the tab at the top
of the switch with a screwdriver to
disengage the tab from the console,
then pivot the switch away from the
console to remove.
Vertical Switches (Push Button)
shaft of the switch. Buttons are not re-
moved prior to switch removal.
2. To replace - Align the rib on the bot-
tom of the switch with the slot in the
console, then pivot the switch up into
the console till the tab engages the
console securely. Check to be sure the
locating tabs on either side of the
switch's lower alignment rib are in
position to properly center and lock
the switch into the lower part of the
console switch opening.
Horizontal Switches (Rotary)
1. To remove· Depress the locking tab
on the switch to disengage the switch
from the locking tab on the console.
Pivot the switch from the console.
3. Remove the two timer mounting
screws now exposed on the face of
the control console.
REGULAR
2. To replace· Position one side into the
console and pivot the other tab into
the console and apply enough pres-
sure to engage the tab into the con-
sole.
EASY CARE I
PERMANENT PRESS
Timer
Mountin
-......;::;=--:.....,..<,,<+--
Screws
--16001145-01
SECTION 3. SERVICE PROCEDURES
3·59
©
1997 Maytag Corporation