Maytag LAT2300 Service Manual page 18

•
o
Water Saver Models
The sudshose (A) connects to the
top diverter valve outlet. The other
end of the hose to the storage tank.
The drainhose (8) is connected to
the bottom diverter valve outlet. The
other end goes into the standpipe. If
a 36/1 standpipe is not available, a
siphon break (C) must be installed to
elevate the drain hose. (See Drain
Facility, Water Saver Models.)
9. Standard Models
Install drain hose and clamp over
siphon break tube on the back of the
washer. Tighten clamp securely.
}
7. Insert hose washer to end of each
water inlet hose.
H
8. Connect hoses to the washer, HOT
on top and COLD on bottom. Turn
on water supply and check for leaks.
16001145
SECTION 1. GENERAL INFORMATION
1·10
©1994 Maytag Corporation