Select Water-Saver Option; Returned Saved Wash Water - Maytag LAT2300 Service Manual

LAW9304
Features may vary according to model
;
Select Water-Saver Option
Turning the selector knob to save
allows water from REGULAR FABRIC
cycles, DELICATE cycles to be pumped
into a storage tub and saved for the
next load.
Note: Water cannot be saved when
PERMANENT PRESS cycles are used. It
is best not to reuse wash water for
washing permanent press items. These
items may pick up soil and lint sus-
pended from previous washings, which
may be difficult to remove.
When the selector knob is turned to
Drain, the wash water is not saved for
reuse. The water drains normally.
Returned Saved Wash Water
To reuse the water for the next load:
(Do not add until the water from the
storage tub has been returned to the
washer tub.)
16001145
1. Push in the cycle control knob and
turn clockwise to the WATER
RETURN "start" position.
2. Pull out the control knob to start
pumping the water from the storage
tub back into the washer. The
washer will start agitating when the
control knob is pulled out and will
continue to agitate until it is pushed
in.
3. After the water has been returned to
the washer tub, push in the control
knob. (A small amount of water and
sediment will remain in the storage
tub.)
4. Add approximately 1/2 the normal
amount of detergent and, if desired,
the normal amount of bleach.
5. Add Wash Load.
6. Reset the control knob to a Regular
Fabrics or Delicates cycle or "start"
on the Quick Cycle. If extra water is
needed for the water level selected,
the washer will add it automatically.
If the temperature selection is on
"HOT", the water added will help
maintain the temperature of the
saved water.
SECTION 2. CONTROLS
2-30
©1994 Maytag Corporation