Maytag LAT2300 Service Manual page 113

SHAFT RETAINING
~-SPRING
9. Rotate the drive gear (counterclock-
wise) to check the transmission for
proper operation.
10. Apply a new bead of Maytag RTV
silastic to the edge of the trans-
7. Insert the agitator shaft in through
the top of the transmission housing.
Align the splines and push together.
8. Place the agitator shaft spring into
the groove portion of the agitator
shaft. Squeezing the spring together
will be required before it can be
inserted into the groove.
6. With all of the parts of this segment
aligned and in place, install the pin
for lock collar and tighten. Use
thread locking compound on pin
threads.
4. Place the pinion in line with the
drive shaft hole, then push the drive
shaft through the various compo-
nents unti I it is flush with the top of
the pinion gear. Some minor
twisting of the shaft will be required
in order to line up all of the splines.
5. Now place the lower lock collar
between the unsplined portion of the
yoke and pinion gear. Push the
shaft into the smaller unsplined
portion of the torque block and yoke.
block towards the bottom of the
washer.
3. Place the copper splined washer on
the bottom and clutch plate washer
on top, and lay them in the slot as
shown.
16001145 SECTION 3. WASHER - SERVICE PROCEDURES
3-45
©1994 Maytag Corporation