Maytag LAT2300 Service Manual page 140

CAUTION - - - - - - - - - - - - - - - - - - - - - - , - - - - - - ,
Always disconnect power supply before making any continuity checks or resist-
ance readings. Always use caution when doing voltage tests.
TIMER NOT ADVANCING
1.
Check voltage at timer motor
No Voltage: Voltage OK:
1. Check Agitation Cycle 1. Timer motor
• Timer contacts
2.
Timer
• Water level switch
2.
Spin Cycle
• Timer Contacts
WILL NOT SPIN
Motor Runs: Motor Will Not Run:
1. Check for belt broken or slipping 1. Door Switch
2.
Clothing stuck between tubs
2.
Water Level switch
3.
Spin Bearing
3.
Speed selector switch
4. Binding tub bearing 4. Timer contacts
5. Binding tub cover 5.
Pump jammed
6.
Brake assembly not disengaging
6.
Motor Protector switch
7.
Power supply
• Check motor with test cord
NOISY AND/OR VIBRATION
1. Check for proper installation
a. Pump Bearings
b. Motor Bearings
c. Lower Bearing
d. Suspension Springs
In Agitation:
1. Agitator loose
2. Check for pu mp belt loose
3. Transmission
16001145
In Spin:
1. Spin Bearing
2. Tub Seal
3. Inner Tub loose
SECTION 4. TROUBLESHOOTING
4-10
©1994 Maytag Corporation