Maytag LAT2300 Service Manual page 133

CAUTION
Always disconnect power supply before making any continuity checks or resist-
ance readings. Always use caution when doing voltage tests.
SYMPTOM CAUSES TEST PROCEDURE SOLUTION
Washer will not spin No power to washer Check 120 VAC input
Plug in washer.
or agitate to the washer
Reset breaker or
replace fuse.
Lid Open "1E" will persist in .Shut lid
washer display if lid
isn't shut
Lid Switch Check for continuity Replace lid switch
across lid switch with
the lid shut
Motor Check for continuity Replace
from control board
wiring/Replace motor
output to motor run
relay and from relay
contacts to the motor
Control Board Perform motor check
Replace control board
Motor Run Relay Put washer into spin Replace motor run
and check for relay relay
contact closure
Washer spins instead Reversing (Spin) With power off check
Replace reversing
of agitates Relay
relay for welded con- relay
tacts
Control Board
Replace control board
Washer agitates in Washer agitates in Check for 24V across Replace wiring, relay
spin cycle spin cycle relay coil - (control coil, or control board
board problem)
Reversing (Spin) Put washer into spin Replace relay
Relay and check for contact
closure
Control Board
Check for continuity Replace control board
from spin relay tei
control board output
and from spin relay
contacts to the motor
terminals.
Wire harness
Replace wiring
16001145
©1.994 Maytag Corporation
SECTION 4. TROUBLESHOOTING
4-3