Amperate Chart; Voltage Checks With Ammeter; Motor Test Cord - Maytag LAT2300 Service Manual

AMPERAGE CHART
WASHER
Spin - Start
Spin
Full Tub
Water in Tub
Full Speed Water Out
6.0 amps
6.5 amps
6.0 amps
VOLTAGE CHECKS WITH AMMETER
Voltage readings may be taken by using the leads supplied with the meter. The meter
is preset to read on the 0-300 VAC scale but can be dropped down to 0-150 VAC range
by depressing the red button on the side of the meter.
Motor Test Cord
NOTE
Always plug test cord into a
grounded receptacle.
16001145
A motor test cord may be used to elec-
trically check operation of the various
electrical components without removing
them from the unit. Testing in this
manner merely determines whether or
not the part will function independently
of other electrical components. In order
to make accurate tests, proper con-
nection of the motor test cord is impor-
tant. With the aid of the drawings under
Drive Motor Test, installation of the
motor test cord may be done quickly
and accurately.
SECTION 1. GENERAL INFORMATION
1-18
©1994 Maytag Corporation