Maytag LAT2300 Service Manual page 58

To Soak heavily soiled or stained items
on the Regular or Permanent Press
cycle, push the control knob in after the
washer has agitated a few minutes.
This will stop the washer and let the
load soak. To start washing again, pull
out the control knob, the washer will
resume at the point of interruption.
Start the Washer
Pull out the cycle control knob to start
the washer. It will fill to the selected
water level with the selected wash
water temperature. After filling, it will
agitate for the selected number of
minutes.
The washer will pause briefly
throughout each cycle. These pauses
are normal.
16001145
This washer is designed so that it will
not agitate or spin when the lid is open.
It will, however, 'fill with the lid open so
water is available for pretreating stains
or diluting fabric softener.
Should the lid be opened during a
cycle, the washer will stop; when the lid
is closed the washer will resume it's
cycle at the point it was interrupted.
Note: If an unbalanced load occurs
during the spin, the washer will atom-
ically stop. If this happens, push in the
control knob, wait for the tub to stop
spinning, open the lid, redistribute the
load, close the lid and pull out the
control knob.
SECTION 2. CONTROLS
2·26
..
©1994 Maytag Corporation