Figure 21-8 Firmware Upgrade; Table 21-8 Firmware Upgrade - ZyXEL Communications Prestige 662HW Series User Manual

Prestige 662HW Series User's Guide
take up to two minutes. After a successful upload, the system will reboot. See the Firmware and
Configuration File Maintenance chapter in the parts that document the SMT for upgrading firmware
using FTP/TFTP commands.
Only use firmware for your device's specific model. Refer to the label on the bottom of your device.
Click Firmware to open the following screen. Follow the instructions in this screen to upload
firmware to your Prestige.
The following table describes the labels in this screen.
LABEL
File Path Type in the location of the file you want to upload in this field or click Browse ... to find it.
Click Browse... to find the .bin file you want to upload. Remember that you must decompress
Browse...
compressed (.zip) files before you can upload them.
Click Upload to begin the upload process. This process may take up to two minutes.
Upload
Reset Click this button to clear all user-entered configuration information and return the Prestige to its
factory defaults. Refer to the Resetting the Prestige section.
Do not turn off the Prestige while firmware upload is in progress!
After you see the Firmware Upload in Process screen, wait two minutes before logging into the
Prestige again.
The Prestige automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
21-10

Figure 21-8 Firmware Upgrade

Table 21-8 Firmware Upgrade

DESCRIPTION
Maintenance