Audio Output Options - RED Epic Operation Manual

Digital still and motion camera
Hide thumbs Also See for Epic:
Table of Contents

Advertisement

R E D D S M C O P E R AT I O N G U I D E

AUDIO OUTPUT OPTIONS

 DSMC BRAIN: One (1) 2-channel headphone output. For maximum quality, use high impedance headphones.
 Pro I/O Module: One (1) XLR connector that supports 2-channel line level analog output. The signal strength
of the line out cannot be controlled, and is fixed at –15 dB gain.
 HDMI and HD-SDI monitor: Both output two (2) channels of 24-bit 48 KHz uncompressed, embedded digital
audio. Select and mix the stereo channels in the Monitor Mix menu at Menu > Settings > Audio > Monitor Mix.
To monitor audio via HDMI or HD-SDI, the third-party monitor must support audio.
CONTROL HEADPHONE VOLUME (DSMC BRAIN)
The volume range for Left and Right is –28 dB to –0 dB. The default is –9 dB. To adjust headphone volume,
use the following instructions:
1. Go to Menu > Settings > Audio > Headphone.
2. Move the Headphone sliders up and down to adjust the volume.
3. To toggle mute/unmute, select ACTIVE and MUTE, respectively.
NOTE: To link the volume for Left and Right, go to Menu > Settings > Audio > Channel and select the Volume Sliders
check box. For more information, go to
CONTROL AUDIO MIX (CAM MIX, REAR MIX, AND MONITOR MIX)
The DSMC features a digital audio mixer that controls the volume and stereo settings for each input channel.
The mixer affects audio monitoring (such as headphones) and audio recorded to external devices. The mixer
DOES NOT affect audio embedded in the R3D file.
The range for each channel is 0% to 100%. The default for each active channel is 100%. Channel 3 and Channel
4 are active only when there is audio input via the Pro I/O Module.
The digital mixer normalizes each output to prevent the output from exceeding the signal range. For example, if
you pass Channel 1 to an output at 100%, and then mix Channel 2 into the same output, the level of Channel
1 decreases to 50%.
Assign each audio channel to the Left, Middle, or Right side of the stereo mix. Move the sliders up and down
to adjust the volume.
COPYRIGHT © 2015 RED.COM, INC
"Link" on page
135.
955-0020_V5.3, REV-J |
137

Advertisement

Table of Contents
loading

Table of Contents