Troubleshooting - Infopia Element User Manual

Element auto-coding blood glucose monitoring system
Hide thumbs Also See for Element:
Table of Contents

Advertisement

Troubleshooting

Odpravljanje težav
The following chart may help you identify certain problems, but may not solve all
problems that can occur. Please contact your local representative if the problem
persists.
Message
Problem
Problem with the
blood glucose test
meter
Caused by either
used or wet blood
glucose test strip
Caused by less
blood
Blood glucose test
strip is damaged
User applied the
blood sample
before the LCD
display
was blinking
34
www.infopia21.com
Action Required
Place the battery again, and set
the blood glucose test meter. If
the problem persists, Please
contact your local representa-
tive if the problem persists.
Please insert a new blood
glucose test strip and perform
your test again
Please insert a new glucose
test strip and apply the blood
sample.
Please insert a new blood
glucose test strip and perform
your test again
Please wait for the LCD to
display icon blinking before
applying your blood sample
Troubleshooting
Message
Problem
Problem with the
Auto-coding label
The ambient
temperature is too
low
The ambient
temperature is too
high
The test result is
lower than
0.5 mmol/L
The test result is
higher than
33.3 mmol/L
Action Required
Please insert a new blood
glucose test strip and perform
your test again. If the problem
persists, Please contact your
local
representative
if
the
problem persists.
Place the blood glucose test
meter within the operating
temperature
range
for
10
minutes or more and retest.
Place the blood glucose test
meter within the operating
temperature
range
for
10
minutes or more and retest.
Check the accuracy of your
blood glucose test strip by
performing a glucose control
solution test. If the test results in
a normal reading, re-test your
blood sample two or three
times. If "Lo" persists, consult
your doctor immediately.
Check the accuracy of your
blood glucose test strip by
performing a glucose control
solution test. If the test results in
a normal reading, re-test your
blood sample two or three
times. If "Hi" persists, consult
your doctor immediately.
35

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Element and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF