Assembly And Preparation For Use - Clarke JETSTAR 1800 Operating & Maintenance Instructions

ASSEMBLY AND PREPARATION FOR USE.

A. Water Supply Hose
The inlet hose adapter (1), should be
attached to the water inlet ensuring the
filter, within the port and sealing ring
within the adapter are in both in place
Attach a suitable hose to the inlet hose
adapter, using a worm drive clip, or more
commonly used, a Quick Fit Coupling as
shown at 2, Fig 1.
NOTE:
1. Use a good quality hose of at least
1/2" (13 mm) diameter.
2. Hose, worm drive clips, Quick Fit
Couplings are not supplied but are
available from DIY, Hardware and
Garden Supplies Stores.
Secure the other end of the hose to
your tap using a suitable tap adaptor
(not supplied) CLEAN, cold or hot
water (up to 40°C) can be used.
NOTE:
In some areas, it may be necessary to
ensure that you comply with local
bylaws concerning the use of water
from the mains supply, and the disposal
of possibly contaminated water.
B. High Pressure Hose
Remove the plastic travel cap (if
fitted) from the threaded high
pressure outlet (4, Fig.3), then insert
and push home the high pressure
hose into the connector.
Tighten the ring nut (3, Fig. 3), by hand
taking care not to overtighten.
8
Fig.1
Fig.2
Fig.3