Table of Contents
Advertisement
ASSEMBLY AND PREPARATION
The machine is supplied fully assembled except as detailed below.
Attach the cable and hose storage brackets by sliding
them into place on either side of the handle assembly,
as shown in Fig.1.
Model ELS145 &145R
The lance is in two sections,
the high pressure hose being
integral with the lance
handle and trigger assembly.
Assemble by slotting the
spigot end of the lance into
the handle assembly. Push in
firmly and twist to lock it in
position as shown in Fig. 2.
Model ELS160R
The Lance is also in two sections,
and assembled by screwing the two
halves together as shown in Fig. 3.
The high pressure hose is screwed
to the adapter, just forward of the
trigger assembly
Models ELS145R &160R
The hoses to the 145R and 160R are attached to
the Reel
Model 160R requires the hose to be screwed into
the lance - just forward of the trigger assembly.
Take care not to cross thread the fine threads.
Model ELS145
Screw the loose end of the high pressure hose
from the Lance, into the high pressure outlet at
the front of the machine, shown in Fig. 4.
6
Fig.1
Fig.2
Fig.3
Fig.4
Advertisement
Table of Contents
