Troubleshooting; Accessories - Clarke JETSTAR 1800 Operating & Maintenance Instructions

TROUBLESHOOTING

Fault
Pressure Drops or Oscillates
Motor hums when switched
ON but fails to start
Machine fails to start, no
sound from motor
Motor stops
No detergent delivered
Irregular jet produced

ACCESSORIES

The range of accessories listed below may be purchased from your CLARKE dealer.
Item
5 Litres Detergent (Traffic Film Remover) .......................... 3050821
25 Litres Detergent (Traffic Film Remover) ........................ 3050820
5 Litres Wash 'n' Wax ........................................................... 3050815
Cause
Lack of Water
Water Filter blocked
Mains voltage low
Gun not activated
Power lead extension cable too
small
Plug not connected correctly
Incorrect power voltage
Mains fuse blown or RCD tripped
Thermal Overload has
intervened
Injector clogged
Container empty
Dirty high pressure nozzle in spray
gun
13
Remedy
Check the water tap is fully ON
Clean water filter
Check electrical connections
When switching ON the machine,
operate the gun
Use an extension with
conductors of sufficient cross
section. (See Electrical
Connections)
Check plug and lead and
repair/replace accordingly.
Check the plug, cable and
switch.
Renew fuse or reset RCD
Check to ensure the power
voltage is correct, wait for 5
minutes before trying to start
again. (See Thermal Overload)
Clean the spray gun nozzle
Fill container
Clean high pressure nozzle
Part No.