Thermal Overload; Cleaning Agents - Clarke JETSTAR 1800 Operating & Maintenance Instructions

THERMAL OVERLOAD

The machine is protected against damage which could result should the
machine overheat. If the thermal overload cuts in, allow at least 5 minutes,
to allow the machine to cool, before attempting to restart.
CHEMICAL CLEANING AGENTS
To improve cleaning qualities, it is possible to introduce chemical cleaning
agents (detergents) using the foam lance. This is particularly useful for
washing cars, greasy engine parts, removing oil spots on concrete etc.
Use ONLY those detergents recommended for use with power washers,
such as CLARKE Traffic Film Remover which is a powerful low foaming agent
for car cleaning, patio cleaning etc., or CLARKE Wash & Wax, both
available from your CLARKE dealer.
To prepare for detergent application, ensure the trigger safety latch is set
to prevent the trigger from being pulled accidentally and the machine is
switched OFF. It is not necessary to pull
the trigger to release the pressure.
Remove the lance from the trigger/
handle assembly by twisting it clockwise
looking down from the handle end, and
pulling it free. Insert the detergent lance,
push in firmly and twist anticlockwise to
lock in position.
NOTE: It may be necessary to lubricate
the lance spigot when new to assist when
attaching to the handle.
With the container filled with detergent, screw it on to the detergent lance
ensuring the plastic pick-up tube is in place.
ALWAYS read and comply with the manufacturers instructions
issued with the chemical detergent.
Switch ON and pull the trigger. Spray the detergent on to the vehicle,
patio etc., and allow it to work itself into the grime.
To rinse and clean, set the safety latch, replace the detergent lance with
the main lance, release the safety latch and blast off the dirt.
After using the detergent lance, rinse it thoroughly, together with the
container, with clean water. (See Maintenance)
IMPORTANT:
11
Fig.8