Assembly And Preparation For Use; Parts Lists And Diagrams - Clarke JETSTAR 1550 Operating & Maintenance Manual

ASSEMBLY AND PREPARATION FOR USE.

A. High Pressure Hose
Remove the plastic travel cap from the threaded high pressure outlet,
and screw on the high pressure hose firmly.
The outlet on the Jetstar 1550 and 1600 models is at the front of the unit - opposite
end to power cable inlet, on the Jet 3000 model, it is mounted on the front -
handle end.
B. Lance
At the opposite end to the nozzle is a a spigot with two integral lugs, and
a rubber O-ring. Ensure the O-ring is in place and in good condition.
Insert the spigot end of the lance into the trigger/handle assembly. Push
home firmly and twist to lock it in position. Twist anticlockwise looking down
from the handle end. DO NOT attempt to disassemble the lance.
NOTE: When new, the lance may be a tight fit and a little lubrication, with
vaseline or similar, will assist when joining the parts together.
C. Water Supply Hose
Remove the temporary travel cap from the threaded inlet connection
and ensure that the sealing ring is in place.
The water inlet on the Jetstar 1550 and 1600 models is on the left front of the
unit, on the Jet 3000 model it is mounted on the bottom left - handle end.
Attach a suitable hose to the inlet hose connector, and secure with a
worm drive clip, (hose and worm drive clip are not supplied).
NOTE:
1. Use a good quality hose of at least 1/2" (13 mm) diameter.
2. Check to ensure that the filter is correctly located inside the inlet connection.
Screw on the inlet connector, with hose attached, to the water inlet. This
connection must be tight to avoid leaks.
Secure the other end of the hose to your tap using a suitable tap adaptor
(not supplied) CLEAN, cold or hot water (up to 50°C) can be used.
NOTE:
1. In some areas, it may be necessary to ensure that you comply with
local bylaws concerning the use of water from the mains supply, and
the disposal of possibly contaminated water.
2. Hose, worm drive clips and other accessories are readily available
from all good DIY, Hardware and Garden Supplies Stores.
6
PARTS LISTS & DIAGRAMS
Jetstar 1550 & Jetstar1600
No. Description
1 High Press. Hose c/wHandle Assy
2 Lance Assembly
3 Detergent Lance c/w plastic tube
4 Detergent Bottle
- Detergent Bottle Cap
5 LP Water Inlet Adapter c/w O-Ring
and Rubber Washer
- Hex. Wrench (for turning motor)
- Water Inlet Filter
Jetstar 1550 Jetstar1600
Part No. Part No.
FP60600107.88 FP60600107.88
FP60710100 FP60710000
FP60603800 FP60603800
FP15603400 FP15603400
FP15603401 FP15603401
FP18106400 FP18106400
FP15607000 FP15607000
FP52066500 FP52066500
11