Ricoh MP 6002 User Manual page 923

Encryption key manual settings items
Setting
Address Type
Local Address
Remote Address
Encapsulation Mode
SPI (Output)
SPI (Input)
Description
Specify the address
type for which IPsec
transmission is used.
Specify the machine's
The machine's IPv4 or IPv6 address.
address. If you are
using multiple IPv6
If you are not setting an address range, enter
addresses, you can
32 after an IPv4 address, or enter 128 after an
also specify an
IPv6 address.
address range.
The IPsec transmission partner's IPv4 or IPv6
Specify the address
address.
of the IPsec
transmission partner.
If you are not setting an address range, enter
You can also specify
32 after an IPv4 address, or enter 128 after an
an address range.
IPv6 address.
(Tunnel beginning address - Tunnel ending
Select the
address)
encapsulation mode.
If you select "Tunnel", set the "Tunnel End Point",
the beginning and ending IP addresses. In
"Tunnel End Point", set the same address for the
beginning point as you set in "Local Address".
Specify the same
value as your
Any number between 256 and 4095
transmission partner's
SPI input value.
Specify the same
value as your
Any number between 256 and 4095
transmission partner's
SPI output value.
Setting value
• Inactive
• IPv4
• IPv6
• IPv4/IPv6 (Default Settings only)
• Transport
• Tunnel
Configuring IPsec
157