Using The Installation Shell Script - Ricoh MP 6002 User Manual

1. UNIX Configuration

Using the Installation Shell Script

The installation shell script helps with the setup process. The installation shell script automates some of the
tasks in configuring/etc/hosts, /etc/printcap; creating the spool directory for BSD UNIX; and running
the lpadmin command for System V UNIX.
• Download the installation shell script from our Web site. Keep the installation shell script as local
folders.
• The installation shell script can be used on the following workstations: (it cannot be used with other
types of workstations.)
• SunOS 4.1.4
• Solaris 2.6, 7, 8, 9
• HP-UX 11.x
• Red Hat Linux 6.2, 7.0, 7.1, 7.2, 8
• UnixWare 7.1.1
• OpenServer 5.06
• Depending on security settings when installed, rsh/rcp/telnet may not be usable with Red Hat 7.1
or later. Change the security level to allow use of rsh/rcp/telnet. For details about how to change
the setting, see the operating instructions for Red Hat.
• When you use NIS (Network Information Service) or DNS, you should configure the server before
running the installation shell script.
• Installation shell script does not support CUPS.
• When you use Solaris and HP-UX, you can set UNIX configuration with admintool that came with
Solaris and HP-UX. For details about configuring using admintool, see the admintool's manual.
• For details about the configuration utility of your operating system, see the manual that came with
the utility.
Assigning the IP Address
• Configure the machine to use TCP/IP.
• Make sure that TCP/IP on the machine is set to active. (Default setting is active.)
• Assign an IP address to the machine and configure the other settings required for TCP/IP.
8