Table of Contents
Advertisement
1 Introduction
The AE Techron 2105 is a high-power, DC-enabled
linear amplifier and integrated power supply that
offers a wide bandwidth and exceptional control of
drift and distortion. The 2105 functions as a volt-
age or current source and operates using single-
phase power, making it ideal for use in the lab or
classroom. Its linear design provides a very-low
noise floor and fast current rise times. Because
the 2105 has no ripple noise, no synching with the
console is required.
The AE Techron brand is known throughout the
world for its robust, low-noise gradient amplifiers
as well as its product service and support.
1.1
Features
•
Output of 50 amperes peak, 150 volts.
•
4-quadrant linear design.
•
Blanking feature lowers the noise floor on the
amplifier by shutting down the output stage.
This action occurs in less than 10 µs.
6
Figure 1.1 – 2105 Front Panel
•
Current mode response: DC-5 kHz (compen-
sation dependent); Voltage mode response:
DC-20 kHz at rated power.
•
Efficient design and light-weight chassis materi-
als allow amplifier to occupy only 2U height,
and weigh only 41 lbs.
•
Robust, linear power supply results in extreme-
ly low noise; bi-level switch design limits heat
dissipation to output devices.
•
Provides precision control of output offset, DC
drift and gain linearity.
•
Protection circuitry guards against input over-
loads, improper output connection (including
shorted and improper loads), over-temperature,
over-current, and supply voltages that are too
high or low.
•
Shipped ready to operate from 120-volt (±10%)
single-phase AC mains; 220/240-volt model
available on request.
Information subject to change
2105 OPERATOR'S MANUAL – SECTION 1
97-2105006_4-2-15
Advertisement
Table of Contents
