Table of Contents
Advertisement
Quick Links
LVC5050RLY
Supplement
Table of Contents
Pre-Installation................................................... 2
Safety Conventions ............................................ 2
General Description ........................................... 3
Installation ......................................................... 4
Operation ........................................................... 5
Specifications..................................................... 6
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AE Techron LVC5050RLY
Summary of Contents for AE Techron LVC5050RLY
- Page 1 LVC5050RLY Supplement Table of Contents Pre-Installation........... 2 Safety Conventions ..........2 General Description ........... 3 Installation ............4 Operation ............5 Specifications............. 6...
-
Page 2: Pre-Installation
Pre-Installation This LVC5050RLY Supplement describes safety conventions used within this document and provides essential information about the Model LVC 5050RLY amplifier. Review this material before installing or operating the amplifier. AE T is committed to continuous product improvement. ECHRON Technical progress may result in minor variations between this manual and a particular unit. -
Page 3: General Description
1-ohm or lower impedance loads. It accomplishes this with extremely low harmonic and intermodulation distortion and low noise. The features of the LVC5050RLY are the same as the standard LVC5050 amplifier with the following exceptions: ... -
Page 4: Installation
This mode of operation is intended for driving loads with a total impedance of less than 4 ohms. Should the amplifier be accidentally changed out of this mode, below are the instructions to allow for the LVC5050RLY to be returned to that condition. To activate Parallel-Mono mode:... -
Page 5: Operation
Please refer to pages 8-15 of the LVC5050 Quick Start Guide for detailed information on the LVC5050RLY front- and back-panel functions. Output Connectors The LVC5050RLY back-panel features a high-current output block, as shown below. Connections are made via high-current binding posts. Page 5... -
Page 6: Specifications
Specifications Specifications are for units driving into an 8-ohm loads, (26 dB = 20 times voltage gain) and operating from 120 VAC, unless otherwise specified. “Standard 1 kHz Power" refers to maximum average power in watts at 1 kHz with 0.1% THD. “Full Bandwidth Power"... - Page 7 PIP card and may be enabled or disabled. Back Panel: A 3-position switch selects Dual, Bridge-Mono, or Parallel-Mono mode. NOTE: The LVC5050RLY should only be operated in Parallel-Mono mode. Internal: Switches behind the front grill allow selection of normal VZ operation, lock to low voltage only, lock to high voltage only, and lock to low voltage under ODEP conditions.
- Page 8 Connectors Inputs: Euro-style screw terminals will accept up to 16 gauge bare wire. Outputs: Unique output bus with high current binding post. AC Line: “TT" style, 3 wire, 30A grounded connector (for 120 VAC units). Construction Black splatter-coat steel chassis with specially designed flow- through front to rear ventilation system with computer- controlled forced air-cooling.
Need help?
Do you have a question about the LVC5050RLY and is the answer not in the manual?
Questions and answers