AE Techron 2105 Operator's Manual page 5

List of Figures
Figure 1.1 - 2105 Front Panel .......................................................................................................6
Figure 3.1 - Close-up of the Output Terminal Resistor ..................................................................9
Figure 3.2 - Controlled Voltage Hookup ........................................................................................9
Figure 3.3 - Close-up of SIM card .................................................................................................9
Figure 3.4 - Input Select switch functions on the Input Terminals ...............................................10
Figure 3.5 - Close-up of AC Mains Outlet ...................................................................................10
Figure 3.6 - Sample of Configurations Setting Label ..................................................................10
Figure 4.1 - Power Switch ...........................................................................................................11
Figure 4.2 - Gain Control.............................................................................................................11
Figure 4.3 - Push Buttons ...........................................................................................................11
Figure 4.5 - Main Status Indicators for Stand-Alone Amplifiers...................................................12
Figure 4.4 - Main and Fault Status Indicators .............................................................................12
Figure 4.6 - Fault Status Indicators for Stand-Alone Amplifiers ..................................................13
Figure 4.7 - Main Status Indicators for Multi-Amplifier Systems .................................................14
Figure 4.8 - Fault Status Indicators for Multi-Amplifier Systems .................................................15
Figure 4.9 - Back Panel Controls and Connectors ......................................................................16
Figure 5.1 - Access Panel Screw Locations ................................................................................17
Figure 5.2 - Main Board Location Inside Access Panel...............................................................17
Figure 5.3 - Master/Slave Setting................................................................................................18
Figure 5.4 - Gain Trim Control.....................................................................................................18
Figure 5.5 - Controlled-Voltage/Controlled-Current Mode Setting ..............................................19
Figure 5.6 - Compensation Setting .............................................................................................19
Figure 5.7 - Run Mode/Stop Mode on Power-Up Setting............................................................20
Figure 5.8 - Standby Mode on Over Load Setting.......................................................................20
Figure 5.9 - Accessing the Power Supply Board .........................................................................21
Figure 5.10 - Location of Amplifier High-Voltage Transformer Sockets.......................................21
Figure 5.11 - J3 and J7 Plug Locations for High-Current Output ................................................21
Figure 5.12 - J4 and J8 Plug Locations for High-Voltage Output ................................................21
Figure 5.13 - Bi-Level Power Switch Location ............................................................................22
Figure 6.1 - Input to Output Comparison, Controlled-Voltage Operation ....................................23
Figure 6.2 - Input to Output Comparison, Controlled-Current Operation ....................................23
Figure 6.3 - Factory-installed Default RC Network......................................................................24
Figure 6.5 - Compensation Effects on Waveform .......................................................................26
Figure 6.4 - Custom Compensation Location..............................................................................26
Figure 6.6 - Square Wave Showing a Decrease in R is Required ..............................................26
Figure 6.7 - Square Wave Showing an Increase in R is Required ..............................................26
Figure 6.8 - Square Wave Showing an Increase in C is Required ..............................................26
Figure 6.9 - Remote Status and Control Pinouts ........................................................................27
Figure 6.10 - Remote Status and Reset Schematic ....................................................................28
Figure 6.11 - Remote Run/Standby Monitor ................................................................................29
Figure 6.12 - Remote Enable/Standby ........................................................................................30
Figure 6.13 - Remote Current Monitoring ...................................................................................30
Figure 6.14 - Remote Current Monitoring, Alternate Method ......................................................31
Figure 6.15 - Blanking Activation.................................................................................................31
Figure 7.1 - Board-Level Functional Block Diagram ...................................................................36
Figure 9.1 - +Vcc and -Vcc Point Locations ...............................................................................38
Figure 9.2 - Fuse F1 Location .....................................................................................................39
Figure 9.3 - Interlock I/O Connector ............................................................................................39