Table of Contents
Advertisement
10.4 Chimney Liner Installation
The use of a chimney liner (rigid or flexible) is recommended
to ensure the best performance.
draft, it is also strongly recommend adding a minimum of
12" rigid liner between the top of the masonry chimney
and the rain cap. In all cases, liners should be installed
in accordance with the liner manufacturer's instructions,
including instructions for extension above the masonry.
Use chimney liners listed UL 1777, ULC S635 or CAN/
ULC S640.
In order to connect the insert to the liner, refer to section
«10.5 Chimney Liner
ATTENTION INSTALLER:
When positioning the unit in a fireplace opening, prior
to the flue installation, install the insert into the opening
until the top lip of air jacket is flush with fireplace facing.
If lag bolts or anchors are to be used to secure the
insert, the hole location should be marked with the unit
in place. Remove the insert and locate the anchors.
10.5 Liner Connection
Two options are possible to connect the liner to the insert:
10.5.1 Liner Starter Adaptor
Install the chimney liner starter adapter, provided with the
chimney liner. Follow the chimney liner starter adapter
manufacturer's instructions.
In order to connect the chimney liner starter adapter
to the flue outlet, install three brackets with the three
screws, all provided in the user manual, on top of the
insert. The long end of the brackets must be attached
to the insert. Insert the chimney liner into the flue
collar of the unit and secure the liner to the brackets
with three self-tapping screws (not included).
Installation and Operation Manual - Inspire 2000 Insert
To ensure an optimal
Installation».
RAIN CAP
RIGID LINER
12"
FLASHING
305mm MIN.
36"
914mm MIN.
MASONRY FLUE
6" STAINLESS STEEL
RIGID OR FLEX LINER
Figure 29: Liner Installation
Figure 30: Securing the brackets
Page 37
Hide quick links:
Advertisement
Table of Contents
