Head/Carriage Unit; Old Type Of Head/Carriage Unit - Brother MFC-3340CN Service Manual

5.1.14 Head/Carriage Unit

During disassembly jobs, except when removing the ink refill ASSY or engine unit (including the
maintenance unit), leave the head/carriage unit and all four ink cartridges in the machine.
Before removing the head/carriage unit, ink refill ASSY or engine unit, you need to replace the
current ink cartridges with dummy ones and drain ink from the ink refill ASSY and head/carriage
unit (see Section
ones.
The machine is available with two types of the head/carriage units--old type with FFC sponge and
new type with FFC support. For the former one, see
5.1.14.2.
NOTE: When replacing the head/carriage unit, put on a grounding wrist band and perform the job
on a static mat. Also take care not to touch the conductor sections on the flat cables.
NOTE: To replace the head/carriage unit, you need to turn the machine on and let the
head/carriage unit travel to the head replacement position as described in
code 63). Do not move the head/carriage unit by hand when the machine is turned off. However, if
the head/carriage unit fails to move in
page counterclockwise (viewed from the left) by hand to unlock the head/carriage unit and move it
to the head replacement position.
NOTE: If you replace the head/carriage unit, also replace the ink cartridges. This is because
sufficient ink volume is necessary for refilling the ink supply tubes after replacement of the
head/carriage unit.

5.1.14.1 Old Type of Head/Carriage Unit

Draining the ink from the ink supply tubes and moving the head/carriage unit to the head
replacement position (Refer to
(1) Make sure that:
- the ink in the ink refill ASSY and head/carriage unit has been drained,
- all four ink cartridges have been replaced with protective cartridges,
- the head/carriage unit is placed in the head replacement position, and
- the power cord is unplugged from the electrical outlet.
5.1.1). After ink draining, be sure to set protective cartridges instead of dummy
Section 5.1.1,
Section
Section 5.1.14.1; for the latter one, see
rotate the ejection idle gear shown on the next
5.1.1.)
5-25
Section
Section 5.1.1 (Function
Confidential