Recording Head And Cutter Unit - Brother FAX-170 Service Manual

1.14 Recording Head and Cutter Unit

(1) Push down the front edge of the recording head and move it back to the rear to release
the tabs from the cutter unit.
NOTE: Take care not to lose the three springs placed under the recording head.
NOTE: Never disassemble the cutter unit.
Recording head harness
Reassembling Notes
• When installing the recording head, make sure that the three springs are set on the
bosses of the cutter unit.
• Make sure the recording head harness goes through the cutout provided in the cutter unit.
• It is recommended that you install the platen right after putting the recording head back
into place. If not secured by the platen, the recording head could easily come out with
any impact.
Tabs
Springs
IV – 26
Recording head
Cutter unit
(Front)