7 ] Margin Adjustment In Near-Edge Printing - Brother MFC-3340CN Service Manual

[ 7 ] Margin adjustment in near-edge printing

(1) On the PC, run "FILEDG32.exe" in the folder created in
The Filedrgs window appears as shown below.
(2) Drag and drop the "EDGE_CHECK.PRN" onto the BHL2-Maintenance Printer icon in the
Filedrgs window shown above.
The machine displays the "RECEIVING DATA" on the LCD and prints out the margin check
pattern (see a sample printout on the next page).
(3) Measure the left and right margins on the printout.
(Example) Left: 1.0 mm, Right: 1.3 mm
If both margins are within the range from 0.9 to 1.1 mm, no adjustment is required.
(4) If either margin is out of the specified range, press the 6 key twice on the machine.
The "MEDIA SENSOR ADJ" appears again.
(5) To make the machine ready for data entry, press the * key.
(6) Enter the measured value (in units of 0.1 mm) multiplied by 10.
(Example) Left: 10, Right: 13
In this example, press 1, 0, Menu/Set, 1, 3, and Menu/Set keys.
(7) Upon completion of the entry, the machine automatically returns to the initial stage of the
maintenance mode.
Go back to step (2) and print out the margin check pattern again.
(8) Measure the left and right margins on the printout.
If both margins are within the range from 0.9 to 1.1 mm, the adjustment is completed.
TIP: To reset the newly entered values to defaults, press the Black Start (Mono Start) key.
Section 6.1.1.
6-19
Confidential