Digital Watchdog Stand-alone DVMR User Manual page 9

8Channel stand-alone DVMR
Now, hit the "Release" button and then hit "Renew". If all goes well, you'll get new information, and it is for your
DVMR unit. Write down this information on separate paper and input IP Address, Subnet Mask, and Default
Gateway into your DVMR to which you want to access via IP network.
⒞ Confirm if IP Address is working by executing pingtest
Execute pingtest with IP Address which you assigned to DVMR unit, check if it is successful before you try to
access to DVMR unit via IP network. If it is not successful, you may not be able to access to DVMR unit via
IP network, and we recommend you to get help from your network administrator.
4. Live view via IP network
Click Remote Viewer icon to view live pictures via IP network. You will see then following window.
Function of each button in live-view window :
1) : Power switch. Press power switch to quit. Before press power switch button, press disconnect button first.
2) : Connect button. Press connect button to connect to DVMR unit via IP network to see live pictures of
DVMR unit.
You will see the same live pictures, which are displayed on monitor of DVMR unit with a certain time
delay depending on transfer rate of IP network.
3) : Disconnect button. Press disconnect button to cut connection to DVMR unit via IP network.
4) : Screen division button. You can select to see pictures of any single channel, 4, 9, and 16 channels at the
same time. You can select channel number from 1 to 16 to see pictures of selected channel. If you
selected 4, you swill see channel number from 1 to 4 are all activated.
5) : Channel number button. You can select channel number to see live pictures from selected channel.
6) : Status window. It shows Date and Time. Further it displays "Connection established" and a circular fan
on the left bottom is rotating when connection button is activated, or "Waiting for connection" when
disconnection button is activated.
5.Menual for Remote Viewer Software(TCP/IP)
ALL ABOUT IMAGE RECOGINITON & PROCESSING
1
6
7
8
4
2
3
5
33
8Channel stand-alone DVMR
Chapter 2. Procedure
2-1. Camera Connection
Connect the camera to the CAMERA INPUT on the Rear Panel of the system.
Setting video system : In the process of booting, we can set video type (NTSC or PAL) using direction buttons.
While you press [UP] and [LEFT] button at the same time, turn on DC power switch on the front panel to set
video type at NTSC. Immediately after you turn on DC power switch, you will hear beep sound, and it is set at
NTSC and stop pressing [UP] and [LEFT] button. If you turn on DC power switch with [UP] and [RIGHT] button
pressed, it is set at PAL system. Setting is memorized in the system, and it is not necessary to do it again in the
next booting, unless you change video system of camera.
2-2. Monitor Connection (Composite Connection Method)
Connect the monitor to the MONITOR OUT on the Rear Panel of the system
Screen positioning : If picture displayed in your monitor is not at the center of monitor, you can relocate
images to make them shown in the middle of monitor. Press [P/T] button for a long time to enter into screen
position mode, and you can adjust location of pictures using [UP], [DOWN], [LEFT] and [RIGHT] buttons.
Press [P/T] button for a long time again to quit screen positioning mode.
If you press [ENTER] button in the process of screen positioning mode, location of pictures return to original
location set by manufacturer.
Notice : Connect camera or monitor to DVMR unit while DC power switch on the front panel is off.
2. Installation
ALL ABOUT IMAGE RECOGINITON & PROCESSING
Rear part of CAMERA
6