Vcr & Video Printer Connection - Digital Watchdog Stand-alone DVMR User Manual

8Channel stand-alone DVMR
2-3. Monitor (S-VHS) Connection
Connect S-VIDEO Monitor to MONITOR OUT(S-VHS) on the Rear Panel of the system.
2-4. VCR & VIDEO PRINTER Connection
Connect VCR or VIDEO PRINTER to VCR OUT on the Rear Panel of the system.
2. Installation
ALL ABOUT IMAGE RECOGINITON & PROCESSING
7
8Channel stand-alone DVMR
3. How to get IP for DVMR unit
There is 2 different ways to input IP address and other data into DVMR unit.
The first way is to make DVMR system get IP address from DHCP server automatically.
It is only possible in case DVMR unit is connected to cable modem (dynamic IP), Intranet under DHCP
server or IP sharer which support DHCP. Select "DHCP" in TCP/IP setup to get IP address automatically.
The second way is you get IP address and other data before you connect DVMR unit to network and later
input this IP address and other data into DVMR unit. Except the case you already know IP address
assigned for DVMR unit, get IP address for DVMR unit as following process in the client PC from which
you want to access to DVMR unit via IP network. If you connect DVMR unit to leased line with static IP
already known, it is not necessary to follow following process to get IP information.
a) "ipconfig" or "winipcfg"
Execute "ipconfig" command in the client PC with Windows 2000 and Windows XP, and "winipcfg"
command in the client PC with Windows 98 and ME, and you will get IP informations, that are IP
Address, Gateway, Subnet Mask. Write down those numbers and input into DVMR unit to which you are
going to access via IP network. As far as DVMR is in operation without turning off, it is considered that this
IP Address is assigned just to this DVMR unit. Then, restart the client PC to get different dynamic IP
address for client PC after you get IP information for DVMR unit. Derail procedure to get IP information in
different Windows is as follows.
ⓐ Window 2000
First you need to get to the command prompt using the command shell. The best way is from the
run menu.
Start--> Run --> and type in Command. Then either hit enter or click OK. At the command prompt,
type in ipconfig. This will pull up the information that you need to find IP Address for DVMR unit.
ⓑ Windows XP
If you want to get IP Address for your DVMR in Windows XP, you can run ipconfig in one easy step.
Open Run and type "cmd /k ipconfig" without the quotes. This will open the command prompt and
start ipconfig the easy way. Assign IP Address you get to DVMR unit.
ⓒ Windows 98 and ME
To run winipcfg, grab the Run item from the Start menu and type winipcfg into the Open: box. Hit
OK (or RETURN). Those comfortable with DOS can launch it from a DOS prompt.
When winipcfg launches, you'll get a window like this one:
5.Menual for Remote Viewer Software(TCP/IP)
ALL ABOUT IMAGE RECOGINITON & PROCESSING
32