Digital Watchdog Stand-alone DVMR User Manual page 3

8Channel stand-alone DVMR
ALL ABOUT IMAGE RECOGINITON & PROCESSING
8Channel stand-alone DVMR
FCC INFORMATION
A CLASS A computing device subject to certification by the Commission shall be identified pursuant to
par.2.925 et Seq of the chapter. In addition, the label shall include the following statement:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired operation.
Where a device is constructed in two or more sections connected by wires and marketed together,
the statement specified in this Section is required to be affixed only to the main control unit.
The users manual or instruction manual for the EUT shall contain the following statement or eqivalent.
Caution : Changes or Modifications not expressly approved by the party responsible for compliance could void
the users authority to operate the equipment.
If the EUT requires accessories such as special shielded cables and/or connectors to enable compliance with
emission limits, the instruction manual for the EUT shall include appropriate instructions on the first page of the
text concerned with the installation of the device that these special accessories must be used with the device.
It is the responsibility of the user to use the needed special accessories supplied with the equipment.
For a CLASS A digital device or peripheral, the instructions furnished the user shall include the following or
similar statement placed in a prominent location in the text of the manual.
Note : This equipment has been tested and found to comply with the limits for a CLASS a digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of the
this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
ALL ABOUT IMAGE RECOGINITON & PROCESSING