Requirements; Hardware Requirements; Additional Requirements; Setup Procedure - Net2Phone Max 410 Quick Start Manual

Net2Phone MAX 410 – Quick Start Guide

Requirements

Hardware Requirements

To use the Net2Phone MAX 410, you will need:
• A Net2Phone MAX 410 unit and power cord.
•
A Local Area Network (LAN) with a broadband connection which must
not employ proxy server caching.
•
With FXO interfaces: a PBX, APBX, or KPS with an analog line card
installed.
•
A separate port on the MAX with its own telephone line connection to the
PBX is required for each concurrent telephone call (or conversation)
desired. For example, if capability for three concurrent calls is desired,
then the MAX must have at least three ports, each connected to the PBX.

Additional Requirements

To configure and manage the unit, you will need:
•
An IP address, netmask, and gateway address for the MAX 410 (if your
LAN uses static addresses).
• A Net2Phone account number and PIN (available from your reseller).
•
A PC or Mac workstation with any recent Web browser, connected to the
LAN, for initial setup and system management.
NOTE: On a MAX 410, LAN settings must be configured using a PC with a serial
cable connection if local network does not support DHCP. For details, see
Section 2.1.2, Connecting to the MAX 410 Through a Serial Cable, in the MAX
410 User Guide.

Setup Procedure

A Hardware Installation Guide that describes hardware installation, cabling, and
safety-related issues was provided along with your MAX 410 unit. Please read
that manual in its entirety before beginning your hardware installation. Make sure
you completely understand the issues discussed and, in particular, the safety
warnings given.
The steps in setting up your Net2Phone MAX 410 are:
1. Determine what kind of ports your unit contains and their locations (if you
do not already know).
2. Install the MAX 410 unit and connect the cabling.
3. Configure the MAX's LAN settings so that it connects to your LAN.
4. Log in to the MAX 410 Web Manager.
5. Finish configuring the unit via the Web Manager.
6. Test your installation by making an Internet telephone call.
Page 2
Requirements