Entering A Netmask Address - Net2Phone Max 410 Quick Start Manual

Entering a netmask address

To enter a netmask address:
1. Login via console as described in section "Obtaining the MAX 410's DHCP IP
address".
2. After logging in to the MAX 410, type /config/ip at the command prompt.
3. Type change.
4. Select the IP netmask configuration menu "2" and enter the given IP netmask.
[Example]
SYS_NAME:/CONFIG/IP> change
-------- LAN Parameters --------------------------
LAN IP - 150.150.55.27
LAN Subnet Mask - 255.255.255.0
Default G/W IP - 0.0.0.0
LAN Ether Addr - 00:40:5A:72:25:61
-------- Console Parameters ----------------------
Console BaudRate- 19200 BPS
--------------------------------------------------
-------- DNS Parameters --------------------------
1st DNS SERVER IP - 0.0.0.0
2nd DNS SERVER IP - 0.0.0.0
Domain Name
--------------------------------------------------
1. Change IP Address.
2. Change IP Netmask.
3. Change Def. G/W IP.
4. Change Console Baudrate.
5. Change 1st DNS Server IP.
6. Change 2nd DNS Server IP.
7. Change DNS Domain Name.
0. Exit Menu.
What do you want to change (0-7) ? : 2
Reset the Net2Phone MAX 410 to activate the changes.
To do this, power-off the unit, wait 10 seconds, and turn it on again.
If your LAN is using static addresses, you can now finish configuring your system
using the MAX Web Manager. Proceed to section, "Logging In to the MAX Web
Manager."
-
Page 10