Display Output Settings - Barco ClickShare Installation Manual

Hide thumbs Also See for ClickShare:
Table of Contents

Advertisement

Information on supported "Established Timings" (most legacy timings, e.g. 720x400@70Hz, 88Hz; 800x600@56Hz, 60Hz,
72Hz, 75Hz; ... ; ...)
Supported Standard Timing Identifications (e.g. 1280x1024@60Hz, 1600x1200@60Hz,...)
Detailed Timing Information. The first detailed timing description is the "Preferred Timing" of the display and usually the most
important information in the EDID. It describes in full detail the preferred timing: pixel clock, active pixels, active lines, blanking,
sync width, sync offset (horizontal and vertical),...
About auto resolution
When the ClickShare Base Unit display output is put in auto mode, the display output timings will be based on the Preferred Timing
as described in the meeting room display or projector EDID.
About manual resolution setup
When resolution is selected manually, the timings of this resolution are taken from the information described in the meeting room
display or projector EDID. If a custom resolution is entered that is not described in the EDID, the timing is generated by the Base
Unit following the VESA CVT standard with reduced blanking. The calculation is based on the official VESA calculation.
About Display mode
Extended mode
1
Image 6-12
The content of multiple users will be divided over both screen.
Clone mode
1
2
Image 6-13
The content of multiple users will be shown on one screen. The content of that first screen will be duplicated on the second screen.
6.8

Display output settings

Screen Saver
A screen saver can be activated after a certain time. The delay time to activate the screen saver can be set via the slider bar.
When the slider is set completely to the right, the screen saver will never be activated. Slide the slider to the left until the desired
delay time is reached. This delay time can never be larger than the Display Timeout. A warning will be displayed when the delay
time is larger than the display timeout after clicking on Apply.
R5900004 CLICKSHARE 19/08/2014
2
2 users
1
2
2 users
6. Web Interface
47

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents