Error Code On The Status Menu - Epson All in One Printer User Manual

Hide thumbs Also See for All in One Printer:
Table of Contents

Advertisement

User's Guide
Error Messages
Combination of the IP address and the subnet
mask is invalid. See your documentation.
Recovery Mode
Related Information
"Contacting Epson Support" on page 189
&
"Installing the Optional Units" on page 178
&
"Replacing Maintenance Rollers in Paper Cassette 1" on page 111
&
"Replacing Maintenance Rollers in Paper Cassette 2 to 4" on page 115
&
"Installing Applications" on page 137
&
"Updating Applications and Firmware" on page 137
&

Error Code on the Status Menu

If a job does not complete successfully, check the error code displayed on the history of each job. You can check the
error code by pressing the button, and then selecting Job History. See the following table to find the problem and
its solution.
Code
Problem
001
The product was turned off by a power failure.
106
Cannot print from the computer due to the access
control settings.
107
User authentication failed. The job has been
canceled.
108
Confidential job data was deleted when the product
was turned off.
109
The received fax was already deleted.
110
The job was printed on one side only because the
paper loaded does not support double sided
printing.
201
The memory is full.
Solving Problems
Solutions
See the Network Guide.
The printer has started in recovery mode because the firmware update
failed. Follow the steps below to try to update the firmware again.
1. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the firmware over a network
connection.)
2. Visit your local Epson website for further instructions.
Solution
-
Contact your printer administrator.
Contact your printer administrator.
-
-
If you want to perform 2-sided printing, load paper
that supports 2-sided printing.
❏ Print received faxes from Job Monitor in Job
Storage.
❏ Delete received faxes saved in the inbox from Job
Storage in Status Menu.
❏ If you are sending a monochrome fax to a single
destination, you can send it by using Direct Send.
❏ Divide your originals in two or more to send them
in several batches.
140

Advertisement

Table of Contents
loading

Table of Contents