Epson All in One Printer User Manual page 141

User's Guide
Code Problem
202 The line was disconnected by the recipient machine.
203 The product cannot detect the dial tone.
204 The recipient machine is busy.
205 The recipient machine does not answer.
206 The phone cable is incorrectly connected to the LINE
and EXT. port of the product.
207 The product is not connected to the phone line.
208 The fax could not be sent to some of the specified
recipients.
301 There is not enough storage space available to save
the data in the memory device.
302 The memory device is write-protected.
303 No folder has been created to save the scanned
image.
304 The memory device has been removed.
305 An error occurred while saving the data to the
memory device.
306 The memory is full.
311 A DNS error has occurred.
312 An authentication error has occurred.
Solving Problems
Solution
Wait for a while and then try again.
❏ Make sure that the phone cable is connected
correctly and the phone line is working.
❏ When the printer is connected to the PBX or the
terminal adapter, change the Line Type setting to
PBX.
❏ Select Setup > System Administration > Fax
Settings > Basic Settings > Dial Tone
Detection, and then disable the dial tone setting.
Wait for a while and then try again.
Wait for a while and then try again.
Check the connection of the LINE port and the EXT.
port of the printer.
Connect the phone cable to the phone line.
Print a Fax Log or Transmission Report for previous
faxes from Fax Report in the Fax mode to check the
failed destination. When the Save Failure Data
setting is enabled, you can resend a fax from Job
Monitor in Status Menu.
❏ Increase the storage space in the memory device.
❏ Reduce the number of documents.
❏ Lower the scanning resolution or increase the
compression ratio to reduce the size of the
scanned image.
Disable write protection on the memory device.
Insert another memory device.
Reinsert the memory device.
-
Wait until other ongoing jobs are finished.
❏ Select Setup > System Administration > Wi-Fi/
Network Settings > Advanced Setup > DNS
Server, and then check the DNS settings.
❏ Check the DNS settings for the server, the
computer, or the access point.
Select Setup > System Administration > Wi-Fi/
Network Settings > Advanced Setup > Email
Server > Server Settings, and then check the server
settings.
141