Line Status; Place Dialable Intercom Call - Cisco Unified 8961 User Manual

Calling Features

Place Dialable Intercom Call

Procedure
Step 1
Press Intercom.
Step 2 Enter the intercom code.
Your phone enters whisper mode until the recipient accepts the intercom call. If you are on an active call, that
call is placed on hold.
Step 3 Listen for the intercom alert tone, then begin speaking.
Step 4 Press Intercom to end the call.
Receive an Intercom Call
Intercom allows you to place and receive one-way calls using a dedicated or dialable intercom line.
After receiving the intercom call, the recipient can initiate two-way audio (connected mode) to allow for
further conversation.
Procedure
Step 1 When an intercom call comes to your phone, you receive a message on your phone screen, an audible alert,
and your phone answers the intercom call with mute activated. You can handle the intercom call in one of
these ways:
• Listen to the intercom caller in whisper mode. Any current call activity you are already engaged in
• Press Intercom to switch to connected mode. In connected mode, you can speak to the intercom caller.
Step 2 Press Intercom to end the call.

Line Status

Line Status indicators allow you to view the state of a phone line that is associated with a speed-dial button.
Your system administrator sets up Line Status indicators on your phone.
Line Status Indicators
Line Status indicators show the state of a line.
continues simultaneously. In whisper mode, the intercom caller cannot hear you.
Cisco Unified IP Phone 8961, 9951, and 9971 User Guide for Cisco Unified Communications Manager 9.0 (SIP)
Place Dialable Intercom Call
99